Freight deliveries require a delivery time be scheduled and someone must be present at the time of delivery to inspect and sign for the merchandise. A representative from the freight carrier will call the phone number entered at checkout to schedule the delivery.
For freight deliveries, you have the option of adding a liftgate to your delivery. A liftgate is the device that lowers a product from the truck to ground level.
CPO recommends adding liftgate service for freight deliveries exceeding 100 lbs if you do not have a loading dock or fork lift at the delivery address. Additional charges may apply. The liftgate option will be presented during the checkout process.
Please note that liftgate service only ensures the product is removed from the truck. We recommend you have the additional help of two to four people to move the product to its desired location because drivers are not required to assist.
Requesting liftgate service after ordering may result in additional charges and delays.
|Dust Collection Minimum CFM Required:||350 CFM|
|Dust Port Diameter:||4 in.|
|Electrical Controls - Magnetic Starter:||Yes|
|Fence Size:||14-1/2 in. x 4-3/4 in.|
|Fence Travel (Major and Minor):||4-1/4 in. and 15/16 in.|
|Horsepower:||3 HP, 1 Ph|
|Insert Opening Diameter:||2-9/16 in. and 4-21/64 in.|
|Max. Height w/ 3/4-in Spindle:||7 in. (Above) 6 in. (Below)|
|Motor Phase:||1 Phase|
|RPM:||7,500 / 10,000|
|Router Bit Collet Diameter:||1/4 in. and 1/2 in. (optional)|
|Spindle Capacity Under Nut:||1/2 in. (2-13/64-in) and 3/4 in. (3-3/16-in)|
|Spindle Diameter:||1/2 in. and 3/4 in. Standard|
|Spindle Travel:||3 in.|
|Table Height:||33 in.|
|Table Opening Diameter:||6-9/32 in.|
|Table Size:||25 in. x 25-1/2 in.|
|Table T-Slot:||3/4 in. x 3/8 in.|
Reviewed by 1 customer
Displaying review 1
Comments about JWS-25X, 3HP, 1Ph JET, Shaper:
Pros: Very powerful, quiet, good fence and protection. My sawdust collector is much louder
Cons: The only thing I don't like is that when you release the spindle height lock the spindle drops a fraction. It would be better if it stayed so small adjustment could be made. maybe there is an adjustment for this but I have not found it.
I have made several raised doors with the Freud RP and RS 2000 system and love the extremely smooth cuts this system and shaper produce.
I had a 3.5 hp porter cable router and table -- no comparison. This is way better.
Very prompt Delivery